Cartridge Replacement for Xerox Phaser 6600

Replacing the Xerox Phaser 6600 toner cartridges is a very important part of printing successfully. A bad installation can cause problems that go from bad printing quality to damaging the toner cartridges or other printer parts.

Here are some easy steps that you can use to remove the used toner cartridges and install the new ones without damaging your printer or your Xerox Phaser 6600 toner cartridges.

Before start replacing the Xerox Phaser 6600 Toner keep in mind the following safety recommendations:

CAUTION:

• - Do not burn or throw used toner cartridges into open flames, as this may cause a fire
• - If toner gets onto your hands or clothing, wash it off immediately with cold water. Do not use warm water as this may set the toner permanently, and you may not be able to remove the toner stains

Removing the used Xerox Phaser 6600 Toner Cartridges

1. Open the cover board of the printer.

2. Raise the lever on the Xerox Phaser 6600 toner cartridge and pull it toward you.

Installing the new Xerox Phaser 6600 Toner Cartridges

3. Take the new Xerox Phaser 6600 toner cartridge out of the box and shake it firmly 5 or 6 times.

4. Insert the new Xerox Phaser 6600 cartridges into the printer and push it until it clicks into place.

5. Close the cover board.